6 replies to this topic

[juanvivo]

Hi!


I'm trying to mount this circuit and I have little experience in electronics, so I have a doubt.

I want to ride the circuit without a low voltage detector, and I'm not sure how the scheme should be. Can you help?

Here I put the original scheme, the modification 1 and the modification 2. Which is correct if i dont want the low voltage detector?

tks for your time!

Edited by juanvivo, 02 October 2011 - 09:21 PM.

[Mr.RC-Cam]

If you don't want Low Voltage Detection then remove R2 and D1. Install jumper wire across location JP1.

[juanvivo]

Yes, i can read this in the scheme.

I'm not sure how it would the scheme. Can you tell me what would be the correct scheme of the images that I present? Is necesary JP1?? for what?

scheme modification 1

scheme modification 2

[Mr.RC-Cam]

Use "schem modification 1" and connect PIC pin 3 to PIC pin 8.

[juanvivo]

ok, i will go to do this!

tks!

[juanvivo]

Is posible change the .1uF for a 1uF one?

[Mr.RC-Cam]

a 1uF ceramic cap would be fine.