Jump to content

Gericho

Members+
 View Profile  See their activity

  • Content Count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Gericho

  • Rank
    RC-Cam Visitor
  1. Gericho
    If you mean the extruder stepper, you have to just follow this guide http://reprap.org/wiki/Calibration#Extruder_steps the gear specs doesn't matter. in general you have to modify this line in configuration.h: #define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,2560,XX} If you have the i3 pro B, just change the XX with the value you get following the guide, the rest must remain the same if you mean the axis stepper, I suggest to use the Geeetech firmware here: http://www.geeetech.com/forum/viewtopic.php?f=20&t=17046&sid=fc66f364b549e7aa6b240835d36c0c9e
  2. Gericho
    I'm sorry, but I can't help on this case, but I suggest to contact geeetech at technical@geeetech.com, they normally give a feedback in 24 hours. Could you please share the reply you'll get here? Thank you.
  3. Gericho
    Hi mitch25, as long as I searched for, it seems to be a 100K thermistor, you can find it almost everywhere.
  4. Gericho
    Thank you for the tip! I'll try.
  5. Gericho
    Thank you for your precious help on MK8, may I ask to show where the screw are located on the hotend? I don't want to remove the kapton since I don't have at home. Are there 2 screws? Thank you!
×
×
  • Create New...