Jump to content

Sean Pullinger

  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Sean Pullinger

  • Rank
    RC-Cam Visitor
  1. Sean Pullinger

    PanCam Alternative Setup (Wired)

    Thanks so much. I do have a 555 servo circuit that uses a POT. I will give you feedback once I have constructed and tested the circuit with your Pan-Cam circuit design.
  2. Sean Pullinger

    PanCam Alternative Setup (Wired)

    The connection J1 (RC In) Pin 7 of the PIC12F509 is used for the input of the R/C RX CHNL. Is there perhaps an alternative method of rather using a variable resistor (POT) to connect to Pin 7, VCC and GND? Joy sticks are usually available with a 10k or 20k variable resistor. I will not need a R/C since I will be using this Pan Cam Project for a JIB Arm (Camera Crane) to control the Pan and Tilt operation and the distance is only 4 meters. Any advice will be highly appreciated.