Jump to content

divit

Members+
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About divit

  • Rank
    RC-Cam Visitor
  1. I need to generate pwn signals at port 0.0-0.7 and port 2.0-2.7.The pwm signals should change their Ton period according to digital value received from the adc by each sensor.every pin will hav a different pwn signal according to correspoding value of the sensor.the sensor will basically be a 5k ohm pot .the pwm signals will run a servo motor.the servo motor should move between 0 to 90 degrees.I am also posting the schematic please help me out i need to do this for my final year project I am making a dex hand which works on an adc and AT98S52. I dont knw how to program a ic i have the circuit diagram i just need help if some 1 could giv me the coding for it. There are 16 sensors (i am using 5k ohm pots as sensors) .The sensors are given to the adc the adc will generate a digital value and give it to micro controller.The micro controller will then generate a pwm signal .The pwm signal is then given to the servo motors. I basically need a program which will enable each servo motor to move according to the adc value received.Therefore each each pot will drive a single servo motor.
×
×
  • Create New...