Jump to content

Recommended Posts

Hi all again, I´m not having good results with the GP Patch 2.4Ghz antena. I used a panel mount sma-male conector. Mounted the panel with screws and nuts and solder the center pin to the patch plate(smaller). Should I solder the panel to the reflector plate too? Thanks a lot

Share this post


Link to post
Share on other sites

Soldering is preferred over screws. It is surprising you are not having good luck with the GPP. That is a bit unexpected.

Share this post


Link to post
Share on other sites
It is surprising you are not having good luck with the GPP. That is a bit unexpected.

Yeah I´m very surprised too, I made another ground test in a wide clear field and the image wasn´t clear at 2 mts distance with the GP Patch attached directly to the receiver. The other antennas I tested were great. I don´t know were I made a mistake instead of the panel mount sma conector.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×