3 antennas for 2 receivers?

[robyr1 0]

hi to everybody!!

i just bought a ORACLE diversity receiver from dpcav.com

I'm not a flight hobbyst,but i bought this equipment because i would like to test it on a race track,from an "on board camera",with a 1000mW 2,4ghz.

I have a very big 24db antenna,a YAGI of 10db and an omni panel of 10 db.

I tested equipment with hi gain 24db and YAGY,and it work good (tested in my house only!).

My question:can i put the YAGI antenna and omni panel antenna in parallel?Can i increase my RX with these 3 antenna's?Remember wich my use is not for flight,but for ground!

Here are a sample pic of what i would like to do:

www.onboardcamera.it/txrx.jpg

Any suggest?

[Mr.RC-Cam 123]

You cannot simply install the antennas in parallel. You must maintain impedance matching. Here is a discussion about mixing two antennas together: http://www.rc-cam.com/forum/index.php?showtopic=1528

[robyr1 0]

Thanks a lot for your reply!

[robyr1 0]

here are my 3 antennas available:what can be the best configuration?Remember wich i need to "follow" a bike in a race track!

This is the 24db antenna:

and these are the 2 other antennas:

What's your suggest?

[Mr.RC-Cam 123]

Just use the best pair that works for you. In this hobby, it is all about trying things out.

[robyr1 0]

ok,

what you reccomended for 2 ground to ground "use? big antenna with YAGI?or big antenna with omni panel?

[Mr.RC-Cam 123]

I recommend you try them all. Plus, it might be easiest to try them one at a time to help identify which work well.

[robyr1 0]

ok!

i'll send here my next test!