Jump to content
Sign in to follow this  
Alvaro

LoMoa don´t work ?

Recommended Posts

Hi all...

In my LoMoa when i plug the battery it dont give me any beep...But i dont connect the receiver on it, i will prefeer to make some test out of receiver. The pin 4 (GP3/MCLR) are connected to pin 8 (GND) for this rapid test. Whith this configuration it will beep or something are wrong ? really i need to connect to a receiver for an test?

Share this post


Link to post
Share on other sites

You should be able to hear the three "I'm Alive" beeps at power-up. There is no need to connect Pin 4 to Gnd for this.

Share this post


Link to post
Share on other sites

:(

So...i think that i burn my pic....

the only difference betwen this circuit is that i use this buzzer My Webpage in Brasil the original buzzer in the project are very difficult. But the buzzer are similar.

Share this post


Link to post
Share on other sites

More one detail...i used the PIC12C509A, the software (hex. file) was tested on this pic, the OSCAL are iddentical to the PIC12C508 i believe. I used the ic-prog with JDM hardware.

Share this post


Link to post
Share on other sites

Something are wrong...in my ic-prog the message this:

Warning

No "Oscilador Callibration Value" found.

Do you want to use value from file (0FFFh) instead?

Yes or No

Yes or No...on this message?

:(

Share this post


Link to post
Share on other sites

Hy Mr.Cam....finally it work, the problem was that the COM port are on COM2, i changed to COM1 on the Ic-Prog. The Pic was burn with success. When it is connected to battery it emit 3 beeps....( I Alive). :D

Thanks for your repply.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...