Jump to content
pieter troch

servo tester problems

Recommended Posts

I try to build the servo tester on the R/C cam site. (under special projects)

And I'm getting stuck on programming my pic's!!!

I use pic12c509A and I get a error at 0040h. I don't know anything about hex. or of pics so this is my first time. When I read the pic after programming than I see that he only wrote the lines till 0040. All the rest is left blank.

I use a pic programmer (pic-01 from seeit) and the software is IC-Prog 1.05c

I don't know what I'm doing wrong and already ruiend 3 pics.

Maybe there's a mistake in the hex file I downloaded from the site (rcst_v1.hex) or I need an update from that, but I don't know where to get it from.

Please can somebody help me with some advise cause I would need that servo tester up and working by tomorrow.

Thanx!

Pieter Troch

Belgium

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...