Jump to content

Recommended Posts

I recently purchased a 5V 600mw unit from bwav. Since I know jack about electronics I wanted to know if my wiring scheme looks ok. Any help is highly appreciated since this project does not move until I get confirmation that I am going about this the right way...

post-5-1079410883_thumb.jpg

Edited by psunder

Share this post


Link to post
Share on other sites

Your connections looks fine with the following assumptions:

1) The camera is a 5v camera

2) The microphone is self-powered. The 600mw tx assumes you will be inputting a line-level signal.

3) Your actual wiring layout will be more compact ;)

*DO* implement the capacitors recommended for your vreg. Many models require at least the output capacitor in order to run stable. Use the type specified, and observe polarity.

I would also suggest using the recommended input cap, it never hurts, and almost always helps.

Good luck!

Bill

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...