Jamez_Warner 0 Report post Posted September 22, 2008 (edited) I have a requirement to use one axis of the right stick of my transmitter to control two RC channels, ie: the top portion controls one servo full range and beneath controls a different servo, also full range. I know it would be easy with a PIC, but are there any commercial circuits to allow this? James Edited September 22, 2008 by Jamez_Warner Quote Share this post Link to post Share on other sites
Kilrah 2 Report post Posted September 22, 2008 Not that I know of. But depending on what radio you have you could use mixes to achieve that using 2 channels controlled by the same stick. Quote Share this post Link to post Share on other sites
headhunter23 0 Report post Posted September 23, 2008 Couldn't you just use a y connect and flip servo's to which ever way works? Or use a special y connector that reverses servo... couple other tricks. Otherwise kilrah is right in just using the 2 channels and mix. Ivan. Quote Share this post Link to post Share on other sites
Jamez_Warner 0 Report post Posted September 23, 2008 The mix might work, but I want each half of the stick to control a servo wholey, ie: Top - Servo 1 at max, servo 2at min middle - Servo 1 at min, servo 2at min bottom - Servo 1 at min, servo 2at max Not sure the mix would achieve this? James Quote Share this post Link to post Share on other sites
Kilrah 2 Report post Posted September 23, 2008 That depends on the radio... on mine I could do that. If you have curve type mixes you should be able to do it. Quote Share this post Link to post Share on other sites