Jsaez 0 Report post Posted April 1, 2009 Does anybody know how to adapt the 2.4 module 12X MV (recent launch) in a XP9303 ? This module is the first one who likes a JR product and don´t have that wire to connect the antenna. I just read the topics about DX6 in a 9303, but I don´t know if is valid for this module. Quote Share this post Link to post Share on other sites
Jsaez 0 Report post Posted April 27, 2009 The mechanical connection are done. The PCB was made for the original 5 pinsout JR. You should use a Molex 22-17-2052 connector. Mr. RC-CAM, what should be done with R7 (missing) and R6 1K ????? Quote Share this post Link to post Share on other sites
Mr.RC-Cam 127 Report post Posted April 27, 2009 Mr. RC-CAM, what should be done with R7 (missing) and R6 1K ????? I'm not sure what resistors you mean. With more information, maybe someone in the forum can help out. Quote Share this post Link to post Share on other sites
Jsaez 0 Report post Posted April 28, 2009 General view of 2.4 JR module. See the 5 pin conector. Quote Share this post Link to post Share on other sites
Jsaez 0 Report post Posted April 28, 2009 Here are the R6 and R7 (missing). Quote Share this post Link to post Share on other sites
Jsaez 0 Report post Posted April 28, 2009 Bottom view / open space for 5 pin / etc... Quote Share this post Link to post Share on other sites
Jsaez 0 Report post Posted April 28, 2009 Mr. RC-Cam, What you think about? Quote Share this post Link to post Share on other sites
Mr.RC-Cam 127 Report post Posted April 28, 2009 I don't have any information to offer, but maybe someone else can help you out. Quote Share this post Link to post Share on other sites
