juanvivo 0 Posted October 2, 2011 Report Share Posted October 2, 2011 (edited) Hi! I'm trying to mount this circuit and I have little experience in electronics, so I have a doubt. I want to ride the circuit without a low voltage detector, and I'm not sure how the scheme should be. Can you help? Here I put the original scheme, the modification 1 and the modification 2. Which is correct if i dont want the low voltage detector? tks for your time! Edited October 3, 2011 by juanvivo Quote Link to post Share on other sites
Mr.RC-Cam 129 Posted October 3, 2011 Report Share Posted October 3, 2011 If you don't want Low Voltage Detection then remove R2 and D1. Install jumper wire across location JP1. Quote Link to post Share on other sites
juanvivo 0 Posted October 3, 2011 Author Report Share Posted October 3, 2011 Yes, i can read this in the scheme. I'm not sure how it would the scheme. Can you tell me what would be the correct scheme of the images that I present? Is necesary JP1?? for what? scheme modification 1 scheme modification 2 Quote Link to post Share on other sites
Mr.RC-Cam 129 Posted October 3, 2011 Report Share Posted October 3, 2011 Use "schem modification 1" and connect PIC pin 3 to PIC pin 8. Quote Link to post Share on other sites
juanvivo 0 Posted October 3, 2011 Author Report Share Posted October 3, 2011 ok, i will go to do this! tks! Quote Link to post Share on other sites
juanvivo 0 Posted October 4, 2011 Author Report Share Posted October 4, 2011 Is posible change the .1uF for a 1uF one? Quote Link to post Share on other sites
Mr.RC-Cam 129 Posted October 4, 2011 Report Share Posted October 4, 2011 a 1uF ceramic cap would be fine. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.