Jump to content

Recommended Posts

My Oracle has lost it's video diversity controller (SERIAL NO. D2809377) purchased from RV on

09 October, 2008 will only switch manually. when I switch to vid1 it jumps back to vid2 after a few seconds regardless of the video quality. Even when I swap RX inputs it always stays on vid2. The only way I could get it to stay on vid1 is if I disconnect the video input 2 RX, when I plug it back in it jumps right back to vid2. I've tried changing switching sensitivity, used identical rx, antennas and everything I could think of without any luck. It has worked fine in the past. Any help would be appreciated.

TIA

Share this post


Link to post
Share on other sites

If you've looked over every solder connection on Oracle's board, and they all look good, then I recommend you contact www.dpcav.com to arrange a repair.

Share this post


Link to post
Share on other sites

Hi Thomas,

They all look good and feel tight to me, I'll contact www.dpcav.com to arrange a repair.

Thanks for quick reply.

Kenny

DSC02635.jpg

DSC02632.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...