Jump to content

Recommended Posts

Hi,

I've uploaded MWOSD firmware and one of its feature is that you can change most of the settings via gui interface using your transmitter and goggles.

Best regards

gc 

Share this post


Link to post
Share on other sites

hi,

I have the rodeo 110, i have found this thread seraching for rodeo uart.

I whant to do the same for the rodeo 110, for the osd it's simple.

But i am looking to add a gps or other sensor.

Could you explain how to determine the pin for the serial port?

I don't have an oscilloscope.

please check this two picture

back & front

there are a lot of solder pad ex:

  • on the front nearthe usb (clk)
  • on top 5v
  • the camera connector is the jst near the usb
  • the vtx connector is on the back between the antena (black 6 pin)

 

Share this post


Link to post
Share on other sites
Quote

I want to do the same for the rodeo 110, for the osd it's simple.

FWIW, if you intend to fully integrate the OSD with the Flight Controller's data it will also need to use a serial port for MSP data.

 

Quote

Could you explain how to determine the pin for the serial port?

Use your ohmmeter and determine if any unused connector pins or bare solder pads are connected to the Flight Controller's CPU. Also determine if any CPU pins are unused (nothing connected to them). If you find any of these things, consult the CPU's data sheet and Cleanflight source code to see if they are useful for UART or soft serial.

If your only requirement is to connect the GPS to the MinimOSD to display common GPS data then you don't need the Flight Controller's Serial Port. Use "standalone" connections instead, as explained here: http://intofpv.com/t-osd-standalone-gps

 

  • Like 1

Share this post


Link to post
Share on other sites

Thanks for your reply.

The best is to found the serial header for a complete integration. (but i am not sure to understand the benefit of the full integartion)

The fallback is to use the autonomous minimosd + gps like in the pimousse tutorial.

the initial target is to be able to found my drone in case off crash & the pimousse solution sem's to be a good solution.

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...