Jump to content
Sign in to follow this  
Group Leader

? for Terry ref HAL2100 for camera control

Recommended Posts

Hi Terry,

I've borrowed my friend's HAL2100 to do experiments to use it as an 'auto pan' sensor I mentioned in response to the discussion about Camer/Rudder coupling. I see from one of the other RC-CAM forums that you've used one before. Do you have the instructions for it as I can't seem to get my friends one working? When I connect a servo to an output channel I can make it move by changing the orientation of the sensor as you would imagine. However I can't drive the servo irrespective of the order in which the 4 servo inputs (1 red connector, 3 black) are connected to the receiver. Am I missing something or do you think the HAL is duff?

Thank's for any advice you (or anyone else!) can give.

Share this post


Link to post
Share on other sites

Im not sure I fully understand what you mean but....the red plug is for the gain control and should be the 4th lead out when counted from the face of the unit. Lead 3 is aileron2, lead 2 is aileron1 and lead 1 is for the elevator.

Terry

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×