Jump to content

Recommended Posts

Hi Terry,

I've borrowed my friend's HAL2100 to do experiments to use it as an 'auto pan' sensor I mentioned in response to the discussion about Camer/Rudder coupling. I see from one of the other RC-CAM forums that you've used one before. Do you have the instructions for it as I can't seem to get my friends one working? When I connect a servo to an output channel I can make it move by changing the orientation of the sensor as you would imagine. However I can't drive the servo irrespective of the order in which the 4 servo inputs (1 red connector, 3 black) are connected to the receiver. Am I missing something or do you think the HAL is duff?

Thank's for any advice you (or anyone else!) can give.

Link to post
Share on other sites

Im not sure I fully understand what you mean but....the red plug is for the gain control and should be the 4th lead out when counted from the face of the unit. Lead 3 is aileron2, lead 2 is aileron1 and lead 1 is for the elevator.


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...