Jump to content
Sign in to follow this  
plschwartz

voltage regulator

Recommended Posts

On your picture for this project you have battery plus lead soldered to C2.

I have nothing soldered to C2 and there is a little something already there.

My batteries are soldered to TP7 TP8.

Shall I use these instead or do I need to put something on the thingee on C2

Thanks

Paul

Share this post


Link to post
Share on other sites

If you have cut the board, as shown, then you will need to follow the project's hookup instructions. This is required because some traces are cut away during the size reduction. So, Battery Positive would go to the pad of C2+.

If you are using the board as-is, then use the existing stock wiring.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...