Jump to content


Recommended Posts


I've build an altimeter based on this schema (I did not include the 7805 nor the lcd)

http://geocities.com/SiliconValley/Orchard...ltimetersch.jpg . It works ok on the ground but once I used it on a plane (plugged on a spare channel) I have a lot a noise on the graphic. How can I avoid this ? Is there any technic ? Or maybe should I run ir from a battery ?


Share this post

Link to post
Share on other sites

The MAX ADC and Motorola sensor require clean 5.0VDC +/-5%. I wouldn't expect that from the typical R/C system power buss (power is very dirty, even when a BEC is involved, due to servo activity). It's hard to say if this is the main contributor, so other issues may be involved.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now